HP Virtual Connect Firmware manual 135

•In VC 4.30 and later, the VLAN Capacity (on page 98) places restrictions on the number of networks that can be added to a shared uplink set.

•If the domain stacking mode is configured with horizontal or primary slice stacking links, only uplink ports on the same logical interconnect can be added.

o Based on the first uplink port selected, the list of external uplink ports is filtered to display only ports in the same logical interconnect.

o Remove all uplink ports to reset the filtering.

For more information on the domain stacking mode, see "Stacking links ("Stacking Links screen" on page 231)."

The following table describes the fields within the Define Shared Uplink Set screen.

Field name	Description
Ethernet Shared External Uplink
Set
Uplink Set Name	Descriptive name for the shared uplink set. Do not use spaces.
External Uplink Ports
Port	Enclosure, bay, and port number
Port Role	Displays whether the port is designated as primary or secondary. For shared
	uplink sets with an associated FCoE network, the port role is N/A.
Port Status	Shows the link status, link speed, and connectivity of the port. If the port is
	unlinked and no connectivity exists, the cause is displayed. For more
	information about possible causes, see "Port status conditions (on page
	274)."
Connector Type	The type of connector on the port; for example, RJ-45
Connected To	If the individual port is connected to a switch that supports LLDP, the switch
	LLDP system name or management IP address and switch port number
	appear. A link is provided to obtain more information about the far-end
	switch port.
PID	PID status icon (on or off) for the port
Speed/Duplex	Pull-down menu to specify the speed and duplex (where applicable) of the
	Virtual Connect networks 135