Modify iSCSI HBA connections

Modify FC HBA connection settings, if there are one or more VC Fibre Channel modules in the Virtual Connect domain

Assign, unassign, or re-assign the profile to a device bay

Copy the profile

Delete the profile

Modify FCoE HBA connections

Set FC boot parameters

NOTE: The process to assign, modify, or unassign a profile to an Integrity BL8x0c i2 server blade can take up to several minutes.

If VC-assigned MAC addresses, WWNs, or non-default Fibre Channel boot parameters are being used, the server blade must be powered off before any server side changes can be made. FC, FCoE, or iSCSI boot parameters require the server to be powered off. If the affected server ports all support DCC, and DCC is operating properly, then the server does not need to be powered off to change the network or allocated speed. To power off a server blade, see "Server Bay Status screen (on page 270)" and "Server blade power on and power off guidelines (on page 286)."

Changes to Ethernet network and Fibre Channel fabric settings can be made without powering down the server. For complete information on server power requirements when assigning or removing server profiles, see "Server profile troubleshooting (on page 285)."

Virtual Connect server profiles 206