HP Virtual Connect Firmware System Log (Configuration) screen, Column, Description, To define a new remote log destination, click Define Target

System Log (Configuration) screenUse this screen to view or set remote log destination settings.

Column	Description
Log host	The IP address or the DNS of the configured remote log destination
Log severity	Severity of the log messages that should be sent to the specified destination. Valid
	values include "Critical", "Error", "Warning", and "Informational".
Transport	The transport protocol to be used for sending the log messages to the destination. Valid
	values include "TCP" and "UDP".
	TCP is required if the domain is in FIPS mode ("Virtual Connect FIPS mode of operation"
	on page 314).
Port	The port to be used on the destination to send the log messages. Valid values include
	1 to 65536. The default value is 514.
Security	Secure transmission of the log messages. Valid values include "None" and "STunnel".
	The default value is "None", and no encryption is used during transmission. The
	"STunnel" option can be used only if the transport protocol used is TCP.
	STunnel is required if the domain is in FIPS mode ("Virtual Connect FIPS mode of
	operation" on page 314).
Date Format	The timestamp format for the log messages. Valid values include "RFC3164" (Nov 26
	13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The default value is
	"RFC3164".
Enabled	Enables or disables the remote log destination

To define a new remote log destination, click Define Target.To send a test message to all enabled remote log destinations, click Test.

Virtual Connect domains 51