HP Virtual Connect Firmware manual 194

Item	Description
Use Boot Assistant	Launches the iSCSI Boot Assistant (on page 196). For LHN, you can use the iSCSI Boot
	Assistant to retrieve and populate most of the configuration and authentication data in
	this screen.
iSCSI Boot
Configuration
Initiator Name	Name used for the iSCSI initiator on the booting system. This name is the IQN name for
	the host that is created by the storage administrator. The initiator name length can be
	a maximum of 223 characters.
Target Name	Name of the target from which to boot. This is the IQN name for the storage device that
	is provided by the storage administrator during the LUN setup. The target name length
	can be a maximum of 223 characters.
Boot LUN	The LUN of the target identifies the volume to be accessed. Valid values for standard
	LUNs are 0-255 decimal. Valid values for extended LUNs are 13- to 16-character
	hexadecimal values.
Target Primary IP	Primary IP address used by the iSCSI target
Address
Target Primary Port	The TCP port associated with the primary target IP address. The default value is 3260.
Target secondary IP	Alternate target IP address to use if the primary port is unavailable
Address
Target secondary Port	The TCP port associated with the secondary target IP address. The default value is
	3260.
Initiator Network
Configuration
VLAN id	The VLAN number that the iSCSI initiator uses for all sent and received packets. Valid
	values range from 1 to 4094.
IP Address	IP address used by the iSCSI initiator. This value is in dotted decimal format.
Netmask	IP network mask used by the iSCSI initiator. This value is in dotted decimal format.
Gateway	Default IP route used by the iSCSI initiator. This value is in dotted decimal format.
Authentication Method
CHAP (one-way)	One-way Challenge-Handshake Authentication Protocol. The authentication protocol
	for authenticating initiators and targets. CHAP is one-way authentication; the iSCSI
	target authenticates the initiator. The initiators ‘username’ and ‘secret’ are required.
CHAPM (two-way)	Two-way CHAP. The initiator and target perform two-way authentication. The initiators
	‘username’ and ‘secret’ and targets ‘username’ and ‘secret’ are required for
	authentication.
Username	The user name for authentication when the authentication type is CHAP or CHAPM. The
	maximum length is 223 characters.
Secret	The secret password for CHAP or CHAPM authentication. It can be a string or a long
	hex value (starting with ‘0x’). The value must be at least 12 bytes (or 24 hex digits) and
	at most 16 bytes (or 32 hex digits).
Mutual Username	Mutual username for CHAPM authentication
Mutual Secret	The secret password for CHAPM authentication

Virtual Connect server profiles 194