HP visualize J6000 work stations manual 100

Boot Console Handler

Displaying and Setting Paths

To set a system path to a new value, follow the directions in the section “Accessing the Boot Console Handler” found in this chapter, and type the following at the prompt:

Main Menu: Enter command > path path_type path [Enter]

where path_type is one of the path types listed in Table 5-1 and path is the specification of the path in Mnemonic Style Notation (as described in Table 5-2). For example, to set the primary boot path to a SCSI disk with an ID of 6.0, follow the directions in “Accessing the Boot Console Handler” on, and then type the following at the prompt:

Main Menu: Enter command > path pri scsi.6.0 [Enter]

100 Chapter 4