HP visualize J6000 work stations manual CPUn invoke LDB CPU n is starting the low-level debugger

				Troubleshooting
				Identifying LCD-Indicated Conditions
Table 2-1. Chassis Codes for J6000 Workstations
Ostat	Code	FRU	Message	Description
INI	3n07	SYS BD	CPUn invoke LDB	CPU n is starting the low-level debugger.
FLT	3n09	SYS BD	bad sys mde byte	CPU n detected an unsupported system
				mode.
WRN	3n1A	SYS BD	hversion mismtch	Stable store hardware version doesn’t
				match system.
TST	3n1B	SYS BD	chck model strng	Check model string with version in stable
				store.
WRN	3n1B	SYS BD	model str msmtch	Model string doesn’t match that in stable
				store.
FLT	3n1B	SYS BD	fatal model str	Error reading model string from stable
				store.
TST	3n1C	SYS BD	test software ID	Check LANIC address.
WRN	3n1C	SYS BD	update sw ID	Update LANIC address.
FLT	3n1C	SYS BD	update sw ID err	Error updating LANIC address.
INI	3n2s	SYS BD	Invoke LDB: s	CPU n is awaiting the low-level debugger
				for s more seconds.
TST	3nBC	IO BD	test sys clocks	CPU n is verifying processor clocks with
				the real-time clock.
INI	3nBC	SYS BD	init sys clocks	CPU n has initialized the processor clocks.
FLT	3nBC	IO BD	RTC tick timeout	The real-time clock is ticking too slowly or
				not at all.
TST	3nCD	SYS BD	check defaults	CPU n is initializing stable store values to
				system defaults.
INI	3nCD	SYS BD	init defaults	CPU n finished initializing stable store
				values.
FLT	3nCD	SYS BD	init EEPROM err	CPU n detected an error writing to stable
				store.
FLT	3nEC	SYS BD	bad sys config	CPU n detected an illegal CPU board
				configuration.
FLT	3nF4	SYS BD	EEPROM boot limt	CPU n detected a fatal error writing the
				EEPROM.
FLT	3nFC	SYS BD	bad sys bd id	CPU n cannot identify CPU board.
TST	4n00	SYS BD	CPUn start lst	CPU n is starting its late (with memory)
				self-tests.

Chapter 2 49