Connecting the SCSI and Power Cables
To connect the SCSI and power cables to the autoloader, follow these steps:
1.Shut down and turn off the selected server. Turn off all attached accessory devices, such as printers and other SCSI devices. Remove the power cables from the server and all attached accessories.
Caution Failure to remove the power cables from these devices could result in damage to the autoloader.
2.Attach one end of the SCSI cable (included in the accessory kit) to one of the connectors on the rear panel of the autoloader.
3.Attach the other end of the SCSI cable to the connector on the SCSI host adapter or to the connector on the previous device on the SCSI bus.
Figure 8 Attaching SCSI and Power Cables
Note | If the supplied SCSI cable does not fit the connector on your SCSI |
| host adapter, you either have an incompatible SCSI host adapter |
| or you need to purchase a cable adapter. Contact your service |
| representative or your SCSI host adapter manufacturer for |
| information. |
|
|
Chapter 1 | Installing the Autoloader 19 |
