HP XW3400 Type 1 Battery Holder, Type 2 Battery Holder

Type 1 Battery Holder

1. Lift the battery out of its holder.

2. Slide the replacement battery into position, positive side up.

3. The battery holder automatically secures the battery in the proper position.

4. Replace the workstation access panel (Access panel on page 61).

5. Plug in the workstation and turn on power to the workstation.

6. Reset the date and time, your passwords, and any special system setups, using Computer Setup. Refer to Section 2.2.

Type 2 Battery Holder

1. To release the battery from its holder, squeeze the metal clamp that extends above one edge of the battery. When the battery pops up, lift it out (1).

2. To insert the new battery, slide one edge of the replacement battery under the holder’s lip with the positive side up (2). Push the other edge down until the clamp snaps over the other edge of the battery.

3. Replace the workstation cover or access panel (Access panel on page 61).

ENWW Battery 93