●Wake the workstation by pressing any key on the keyboard or pressing the power button. If the system remains in suspend mode, shut down the workstation by pressing and holding the power button for at least four seconds then press the power button again to restart the workstation. If the system will not shut down, unplug the power cord, wait a few seconds, then plug it in again. The workstation will restart if automatic start on power loss is set in Computer Setup. If it does not restart, press the power button to start the workstation.
●Reconfigure the workstation after installing a
●Be sure that all the needed device drivers have been installed. For example, if you are using a printer, you need a driver for that model printer.
●Remove all bootable media (diskette, CD, or USB device) from the system before turning it on.
●If you have installed an operating system other than the
●If the system has multiple video sources (embedded, PCI, or
CAUTION: When the workstation is plugged into an AC power source, there is always voltage applied
to the system board. You must disconnect the power cord from the power source before opening the workstation to prevent system board or component damage.
ENWW | Helpful hints 121 |