HP XW3400 manual Fan shroud

Fan shroud

1. Prepare the workstation for disassembly (Preparation for disassembly on page 59).

2. Remove the access panel and rotate the workstation so the system board is parallel to the table to make it easier to work on (Access panel on page 61).

3. Remove the hard drive cables from the plastic shroud at the front of the chassis and from the hard drives.

4. Lift the shroud straight up (1) about 5-mm (3/16-in) before pulling it into the chassis (2) to remove it.

NOTE: To install the shroud, reverse the removal process.

84 Chapter 7 Removal and replacement procedures ENWW