7Removal and replacement procedures
Adherence to the procedures and precautions described in this chapter is essential for proper service. After completing all necessary removal and replacement procedures, run the Diagnostics utility to verify that all components operate properly.
NOTE: Not all features listed in this guide are available on all workstations.
Preparation for disassembly
See Identifying routine care and disassembly preparation on page 51 for initial safety procedures.
1. Remove/disengage any security devices that prohibit opening the workstation (External security devices on page 60).
2. Close any open software applications.
3. Exit the operating system.
4. Remove any diskette or compact disc from the workstation.
5. Turn off the workstation and any peripheral devices that are connected to it.
CAUTION: Turn off the workstation before disconnecting any cables.
Regardless of the
6. Disconnect the power cord from the electrical outlet and then from the workstation.
7. Disconnect all peripheral device cables from the workstation.
NOTE: During disassembly, label each cable as you remove it, noting its position and routing. Keep all screws with the units removed.
CAUTION: The screws used in the workstation are of different thread sizes and lengths; using the wrong screw in an application may damage the unit.
ENWW | Preparation for disassembly 59 |