Hughes DW6000 The power supply

Appendix C • Installing the DW6000 using Installer Console
1033295-0001 Revision 2 97
The power supply DW6000 users must use a power supply with the part number
P/N: 1031105-0001. The part number is on a sticker on the power
supply. Verify that you are using the correct power supply. Do not
use anything but the power supply supplied with the DW6000
system (1031105-0001).
Be sure the power supply is labeled AD P 64AB B in the upper
right hand corner of the label, above the bar codes. See Figure 86.
CAUTION
•This unit’s performance may suffer if the wrong power
supply is used.
•This unit must be used with the power supply PN
1031105-0001.
•When power needs to be removed, ALWAYS unplug the
AC power cord from either the wall outlet, surge
protector, or power strip.
•NEVER pull the power cord from the back of the
DW6000. Doing so could damage the pins and also
cause a short in the system.
•Power supply with the part number 1031105-0001 is to
be used only in the United States and Canada.
•This unit must be used with 110-volt AC input.
•Other countries may have different standards and
requirements.
Figure 86: PN: 1031105-0001 and ADP-64AB B above bar code
ADP-64AB B
PN: 1031105-0001