Chapter 3 • The System Control Center
50 1033295-0001 Revision 2
System Info The System Information screen displays a number of fields.
While all the information may be useful at some time, the most
important is discussed below.
Note: Print the System Information screen and tell the customer
to save it. It will be needed should they need to call their service
provider and not be able to access the System Control Center.
DW6000 Info section
Serial number - needed to identify customer’s unit
when troubleshooting.
Software creation date - software build date.
Software release number - version of the software on
the DW6000.
IP Address - the address of the DW6000.
Subnet Mask - defines range of addresses assigned to
the DW6000.
Site ID - Site identification number.
Satellite section
Longitude - displays the satellite’s longitude.
Receive frequency - transponder frequency
configured for the DW6000.
Receive Polarization - polarization orientation,
which is either horizontal or vertical.
Router Address - IP address of the primary router used
to route data sent by the DW6000.
Software Configuration section- Turbo Page, NAT, and DHCP
are enabled or disabled as per a customer’s service offering
and cannot be changed by the customer.
Network Address Translation (NAT) - typically
used to allow multiple computers to shar e a single address
on the Internet. It also allows preconfigured remote
networks to be integrated easily with the DIRECWAY
network.
Dynamic Host Configuration Protocol (DHCP)
if enabled, this simplifies the network configuration of the
computers. The computers just need to be set up to “Obtain
IP address automatically.”
Turbo Page - if enabled, speeds Web surfing.