Appendix C • Installing the DW6000 using Installer Console
1033295-0001 Revision 2 99
1. Take the pedestal base in one hand the DW6000 in the other.
Orient them as shown in Figure87. The Power LED will be
at the bottom.
2. The pedestal base has two curved ridges, one on each side of
its opening. See Figure 88. The DW6000 has six guides that
slide along these ridges. See Figure89. Locate the ridges and
the two guides at the front of the pedestal base.
3. Align the guides with the ridges.
4. Gently slide the guides along the ridges until the DW6000
clicks into place.
S
Note: If you need to remove the DW6000 from the pedestal
base, pull up and back on the tab on the back of the base. See
Figure 90. You can then slide the base off the DW6000.
Figure 87: Orienting pedestal base and DW6000