Hughes DW6000 manual 72

Chapter 4 • DW6000 LEDs and troubleshooting
72 1033295-0001 Revision 2
Problem: Power LED not on If the Power LED is not lit, take the following steps . Note that if
the Power LED is not on, probably no other LEDs will be on or
come on.
•Check to make sure the power cable is securely attached. See
Figure 63.
•If securing the power cable does not solve the problem, check
all cable connections. Tighten any that seem loose.
•If the Power LED still does not come on continuously, power
cycle the DW6000 by unplugging the power cord from the
wall outlet or surge protector, waiting ten seconds, and
plugging it back in.
•If the problem persists, contact in staller support.
Problem: Power LED
blinking
If the Power LED is blinking, take the following steps.
•Check to make sure the power cable is securely attached. See
Figure 63.
•If securing the power cable does not solve the problem, check
all cable connections. Tighten any that seem loose.
•If the Power LED still does not come on continuously, power
cycle the DW6000 by unplugging the power cord from the
wall outlet or surge protector, waiting ten seconds, and
plugging it back in.
•If the problem persists, contact in staller support.