Hughes DW6000 Configure software

Appendix E • Installing DVADB
1033295-0001 Revision 2 131
Configure software Remember you must commission the DW6002 before you can set
up the VADB modem.
1. Op en the User Interface.
2. Click System Information.
3. Verify the software release number is 4.2.0.7 or above. If it is
not, contact installer support to make sure the correct
software is downloaded to the unit.
4. Use a browser to open the Advanced pages. Type the URL for
the DW6002 User Interface and add
/fs/advanced/advanced.html and press Enter. The
Advanced pages interface appears. See Figure124. (You can
also type
www.direcwaysupport.com/fs/advanced/advanced.
html).
5. From the right most drop-down box, select
vadb_config_show(). See Figure 125.
6. Verify vadb_net_enabled and vadb_rem_enabled are both
set to ENABLED. If they are not, contact the NOC and
request the values be updated.
Figure 124: Advanced pages