Appendix E • Installing DVADB
130 1033295-0001 Revision 2
Installation procedure To install DVADB, do the following:
Install the hardware
Configure the software
Test to ensure DVADB is functioning
Before beginning the installation, check the telephone line dialout
sequence. If it does not match the sequence in the installation
specification, or as shown in the Advanced page s, (see
Troubleshooting DVADB on page134), contact installer support.
Install hardware 1. Attach the RJ-11 cable from the DW6002 Gateway telco port
to a phone splitter (such as the one built into a surge
protector). Then connect the splitter to the existing phone
line. The final configuration will look like Figure 123.
Figure 123: Final hardware installation for DVADB
Telephone
cable
Transmit
cable
ACpower
cord
Ethernet
cable
Ethernet
Receive
cable
Power
supply
DCpower
cord