Index

of

Symptoms, Messages,

Error Codes,

or

 

Beeps

 

 

 

 

 

 

 

Table 2-1

on page 2-11

lists

failure

symptoms

and possible causes. The

most likely cause is listed first. Make sure

you complete all items in the

cause

or

“Action/FRU” column. When servicing a

system, always begin with

“Start” on

page 2-2. This index can

also

be

used to help you decide which

FRUs

to

have available

when

servicing a

system.

If you are unable to correct the problem using this index, go to “Undetermined Problem” on page 2-56.

Notes:

1.If an error message and incorrect audio response occur, diagnose the error message first.

2.

If

you

cannot run the Diagnostics and Utilities

tests

but did receive

a

 

POST

error

code,

diagnose the POST error message.

 

 

 

3.

If

you

did

not

receive

any error

message, look

for

a description of

your

 

error symptoms

in

the first

part of

this index.

 

 

 

4. Check all power supply voltages, switch, and jumper settings before you replace the system board. Also check the power supply voltages if you have a system no-power condition. (See “Power Supply” on page 2-34, “System Board Layout—Type A-1” on page 5-2, and “System Board Layout—Type A-2” on page 5-5)

5.Certain models come with a DVD-ROM drive instead of a CD-ROM drive. Diagnose the DVD-ROM drive models the same as the CD-ROM drive models.

6.Type 2142 comes with the Media Console which controls the keyboard, mouse, diskette drive and CD/DVD-ROM drive. Diagnose the Media

Console first, before replacing the system board for problems with the keyboard, mouse, diskette, or CD/DVD-ROM drive. Depending on

service procedures, replace either the Media Console FRU items or the Media Console.

In Table 2-1 on page 2X-11,in

ann

error code can be

any number. If

you are unable to correct

the

problem using this

index, go to “Undetermined

Problem” on page 2-56.

 

 

 

Check Procedures2-9

Page 65
Image 65
IBM 2140, 2142 manual Index, Symptoms, Messages, Beeps