
Removals and Replacements—Machine Type 2140, 2142
| See Safety Notice 1: Translation on page | xi |
|
|
|
|
|
|
| ||
Before removing any FRU, | the computer, unplug all power | ||||
cords from electrical outlets, | then | disconnect any interconnecting cables. | |||
|
|
|
|
|
|
Attention: The system board, processors, adapter cards, DIMMs, and
upgrade processors can be damaged by electrostatic discharge. Use an
electrostatic | discharge | (ESD) strap to establish personal | grounding. | If you | |||
don’t | have | an | ESD strap, | establish personal | grounding by | touching a | ground |
point | with | one | hand before touching the | FRUs. |
|
Note: Machine Type 2140, 2142 might contain drives and devices not illustrated in this book. Follow replacement instructions for the same size device if in doubt. See Appendix B, “Model/Monitor Configurations and FRU Part Numbers” on page
The | arrows | in | the removals and replacements procedures show the | direction | |
of | movement | to | remove a | screw, or to | |
press a tab | to release | the FRU. |
|
Begin all removals by removing the cover (and rear cover, if applicable).
When other FRUs must be removed | prior to | removing | the | failing | FRU, | they |
are listed at the top of the page. Go | to the removal | procedure | for each FRU | |||
listed, remove the FRU, and then | continue | with the | removal of | the | failing | |
FRU. |
|
|
|
|
|
|
To replace a FRU, reverse the removal procedure and follow any notes that pertain to replacement. See “Parts/Test Point Locations” on page
Before disconnecting any cables, note their locations. Reinstall any new FRUs with cables in the same locations.