Board Manual 29
Intel® IQ80321 I/O Processor E valuation Platform
Getting Started
2.6.5 ARM Extended Debugger
For further information on the AXD Deb ugger, refer to the content of the ARM ADS. This setu p
assumes that Angel is Flashed on the board:
Description: Terminal emulat or runs on host a nd communica tes with the b oard via the serial cab le.
Start: Power up the target board. After the ‘reset’ is asserted, the two 7-segment LEDs
display blank. The time for reset is approximately 1 or 2 seconds.
Assumptions: ARM Developer Suite (ADS) is loaded to Win32 Host, Angel is Flashed to ROM,
Host com port is connected to board serial port ## and compiled project file
Worchester.mcp1 exists.
Following are the steps from setup to running a project file that has been previously created and
named Worchester.mcp:
1. From Windows start menu:
a. Programs -> ARM Developer Suite v1.1 -> Metrowerks CodeWarrior
2. From CodeWarrior open project and start debugger:
a. File -> Open (All files) -> Worchester.mcp
b. Project -> Enable Debugger
c. Project -> Debug (AXD Interface comes up)
3. From AXD (ARM extended debugger) configure and connect:
a. Connect Host to Target with serial cable
Options -> Configure Target … -> Set Target Environment = ADP
Select Configure
Select… , ARM Serial Driv er, OK
Endian: Little
Configure… , Serial Port:= COM1, Baud Rate:=115200, OK, OK, OK
b. Load Image and Start
On AXD menu: File -> Load Image… -> File name: Cyclone.axf -> Open ->
c. Execu te -> Select Go, B reakpoints
4. The LEDs now Flashes ‘80321’. You can set breakpoints and step to control speed or stop
location.
1. To be supplied separately.