Threading the Machine
•Threading the machine
* Raise the thread
*Raise the presser foot lifter.
*Place a spool on the spool pin, with the thread coming off as shown.
1Draw the end of the thread around the upper thread guide.
2While holding the thread near the spool, draw the end of the thread down around the check spring holder.
3Firmly draw the thread up from right to left over the
4Slide the thread behind the needle bar thread guide on the left.
5Thread the needle from front to back, or use a needle threader.
•Needle threader q Knob
w Hook e Guide
r Thread end
z Raise the needle to its highest position. Push down the needle threader knob q as far as it will go.
The hook comes out through the needle eye from behind.
x Paying close attention to the needle point, draw the thread around the guide e and under the hook w.
c Release the knob slowly while holding the thread end r with your hand. A loop of the thread is pulled up through the needle eye.
NOTE:
The needle threader can be used with a #11 to #16 needle, or a #11 Blue needle.
Thread size 50 to 100 is recommended.
1
3
4
5
1
3
1
1
2
3
4
2
2
4 
5
2
2
3
28
