TROUBLESHOOTING
PROBLEM | SOLUTION | |
Oven baking results are less | ¥ | The pans being used may not be of the size or material recommended for best |
than expected. |
| results. (See “Cooking Made Simple” booklet). |
| ¥ | There may not be sufficient room around sides of the pans for proper air circulation |
|
| in the oven. |
| ¥ | Check instructions for preheating, rack position and oven temperature. |
|
|
|
Baking results differ from | ¥ | Oven thermostat calibration may differ between old and new ovens. Follow recipe |
previous oven. |
| and use the directions in this guide before calling for service since the calibration on |
|
| the previous oven may have drifted to a too high or too low setting. (See page 20 - |
|
| Temp Adjust.) |
|
|
|
Fan is heard when oven is | ¥ | This is the cooling fan and is normal. The fan will continue to run after use |
turned on. |
| until the oven cools. (See page 12.) |
|
|
|
Cooling fan continues to | ¥ | This is normal. The fan will automatically shut off when the oven has cooled. |
operate after the oven has been |
|
|
turned off. |
|
|
|
|
|
Probe does not work. | ¥ | Check to be sure probe plug is properly inserted into oven receptacle. |
(select models) | ¥ | Probe may not be positioned in food properly. |
| ¥ | Probe temperature may have been improperly set. |
| ¥ | Food may have been too cold or frozen when the probe was inserted. |
|
|
|
Fault Codes | ¥ | The oven may detect a fault during programming or during operation. If a fault is |
|
| detected, the message ÒFault detected - press power to clearÓ or ÒFault detected - |
|
| press enter to try againÓ may appear. Follow directions in the display. If the fault |
|
| reappears or does not clear, call an authorized servicer or the |
|
| display. |
| ¥ | If the same operation is attempted before having the wall oven repaired, the message |
|
| ÒFeature not availableÓ will appear. The feature will remain inoperable until service |
|
| is obtained. |
| ¥ | If the oven is heavily soiled, excessive flareups may result in a fault code during |
|
| cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out |
|
| excess soil, then reset the clean cycle. If the fault code reappears, contact an |
|
| authorized servicer. |
|
|
|
There are no beeps and | ¥ | Oven may be in Sabbath Mode. (See page 21.) |
no display. |
|
|
|
|
|
Noises may be heard. | ¥ | The oven makes several low level noises. You may hear the oven cooling fan going |
|
| on and off. You may also hear the oven relays as they go on and off. These are all |
|
| normal. |
| ¥ | As the oven heats and cools, you may hear sounds of metal parts expanding and |
|
| contracting. This is normal and will not damage your appliance. |
|
|
|
29