NAMES AND FUNCTIONS | – Rear panel – |
OF VARIOUS PARTS |
DV IN/OUT |
|
|
|
|
AUDIO | CH 2/4 | LINE | VIDEO | Y/C |
CH 1/3 |
|
IN |
|
|
|
| REMOTE |
| DC12V |
|
|
| |
OUT |
| NTSC/PAL | 1 |
|
| ||
9PIN |
| SERIAL NTSC PAL |
|
4 3 2
This is used for DC12V input. It connects the DC power cord of the provided AC adapter.
Memo
●When power is supplied to this terminal, the OPERATE indicator located at the front panel lights up. (The LED lights up red when the OPERATE indicator is OFF.)
●Setting this unit to OPERATE ON, OPER- ATE OFF or PLAY mode when the power is supplied to this terminal can be done by mak- ing the appropriate selections from the DC IN MODE item in the SYSTEM menu.
2[NTSC/PAL] NTSC/PAL signal se- lection switchUse this switch to select NTSC or PAL as the signal system. Use it to make a selection when composite video signals or YC separate video signals are input.
NTSC : Use this setting for NTSC signal input.
The NTSC indicator on the front panel lights up.
PAL : Use this setting for PAL signal input.
The PAL indicator on the front panel lights up.
Connect this terminal to the serial remote controller
●Set the REMOTE item of the REMOTE menu to “ON”.
●Set the REMOTE SEL. switch on the front panel to “SERIAL”.
Memo
To use this terminal as the FOOT switch input terminal, please set the FOOT SW item of the REMOTE (2/2) menu. (☞ Page 60)
4[9 PIN REMOTE]Use this terminal to connect to the
●Set the REMOTE item of the REMOTE menu to “ON”.
●Set the REMOTE SEL. switch on the front panel to “9 PIN”.
Memo
●For playback or DV signal input, signals are determined automatically and not affected by the status of this switch.
●Please turn the unit to OPERATE OFF be- fore using this switch. If switching is per- formed when the VTR is in the OPERATE ON mode, the VTR will automatically go into the OFF mode before engaging the ON mode.
●It cannot be used for NTSC/PAL conversion.