Alarm display : Alarm messages are displayed as shown below, when an operation error has occurred or when the unit is in a poor condition for operation. E.g., dirty head.
|
| 3 2 K C H – 1 / 2 | S P 0 0 0 m i n | ||||
A |
|
|
|
|
|
| |
|
| H E A D C L E A N I N G R E Q U I R E D ! |
| ||||
|
| ||||||
B |
|
|
|
|
| ||
|
|
| N O D V S I G N A L |
| |||
|
|
| |||||
|
| 1 0 / 1 0 / 0 2 | S T A N D B Y - O F F | ||||
|
| 1 2 : 0 0 : 0 0 | T C R 0 2 : 0 0 : 0 0 : 0 0 | ||||
|
|
|
|
|
|
|
|
Display at position A : Displays which show the state of the unit (and which are not set via the DISPLAY mode) continues to be displayed here until the conditions are rectified.
Display | Contents |
|
|
LOW VOLTAGE | The voltage of the DC input power is low. Continued operation will bring the unit to the |
| Operate OFF mode. |
|
|
HEAD CLEANING | The video head is dirty. Please clean it with the dedicated |
REQUIRED! | (☞Page 8) |
| If the head is clogged, it will be detected in the PLAYBACK mode and displayed. |
| When the unit enters the STOP mode or the cassette is ejected, the display goes off. |
|
|
OVERHEATING! | The temperature inside the unit has exceeded the regulated value. |
| Please disconnect the power and place the unit in a cool place. |
| If this message is displayed again, damage may have occurred. Please consult with |
| your |
|
|
Display at position B : Messages indicating operation errors are displayed for about 3 seconds.
They are displayed when the DISPLAY mode is ON or AUTO.
Display | Contents |
INVALID TAPE! Data tapes for PC use or DVC PRO tapes has been inserted. The cassette will be ejected.
LP TAPE!The user attempts to play back a tape recorded in the LP mode. This unit cannot record or play in the LP mode.
NO DV SIGNAL The user attempts to record without DV signal input.