Using the Long Roll Accessory
Appendix D-4: Initial Setup of Sensors
IMPORTANT: Do this procedure only if you installed a new sensor or if the sensor setup was accidentally changed.
Resetting the Sensors to the Factory Values
TEACH | ADJ | MODE |
SET | RUN L | D |
1.Move SET/ADJ/RUN to SET.
2.Simultaneously, press and hold TEACH and MODE until nO ? appears (about 5 seconds).
TEACH | ADJ | MODE |
SET | RUN L | D |
NOTE: To cancel resetting the sensors to the factory values, press MODE.
3. Press TEACH until yES? appears.
TEACH | ADJ | MODE |
SET | RUN L | D |
4.Press MODE.
5.Move SET/ADJ/RUN to RUN.
August 2001 |
