Kodak HR 500 manual Setting Image Processing Parameters, Calibrating the Scanner

Using the Service and Assembly Module (SAM)

Setting Image Processing Parameters

1.Select the Data Path.

2.Select the LUT Selected.

3.Select the Dmin Settings.

4.Select the Colors Selected.

5.Select:

•Enable Dark and Gain Corrections

•Enable Defective Pixel Conceal

•Shift Image Data Bits Up by Four

Calibrating the Scanner

IMPORTANT: The 70MM-CAL film holder must be in position in the scanner before you continue. See Placing the Empty Film Holder in the Film Holder Guide on page 2-6.

1.If the values on the Calibrate/Image Processing tab do not match the values shown on the sample on page A-6,change them. The sample is a representation of the default values.

2.Select Shift Image Data Bits Up by Four.

3.Click Calibrate All.

August 2001 A-7