Index

L

lamp

replacing 4-4to 4-5

turning on and off A-10, D-19lamp timer, resetting to zero A-10lamp-and-filter-access door 2-8, 4-4latch release screw 1-4

lens, cleaning 4-2light bar D-12

cleaning 4-3

loading and threading film on the Long Roll Accessory D-16to D-19

location of scanner (specifications) C-1Long Roll Accessory D-1to D-46

attaching to scanner D-8to D-10calibrating sensor offsets D-24to D-33fast forward or rewind speed D-1, D-31initializing sensors D-42to D-44installing accessory on scanner D-5to D-13installing software D-2to D-4

loading and threading film D-16to D-19maintaining D-38to D-41

parts shipped with D-5punch sensors D-14removing from scanner D-13

setting punch reader height D-14to D-23setting trigger points D-34to D-37splicing and editing guidelines D-46table of scan area values D-45threading diagram D-18

M

mag/focus tab (SAM) A-4to A-5magnification, setting 2-8, 3-3, A-5maintaining the scanner 4-1to 4-9, D-38to D-41

cleaning procedures 4-1to 4-3

Long Roll Accessory maintenance D-39to D-41replacement procedures 4-4to 4-9

balance filters 4-6to 4-7IR filter 4-8to 4-9scanner lamp 4-4to 4-5

Mechanical Hazard symbol vi miscellaneous tab (SAM) A-10

N

negative or mounted slide, inserting in the scanner 2-10negative or positive balancing filter, setting 2-8to 2-9

O

operating the scanner 2-8to 2-13focusing 2-13

inserting a negative or mounted slide in the scanner 2-10

placing the film holder in the scanner 2-12preparing an uncarded negative

or a mounted slide 2-11

scanning a single frame 2-13

selecting negative or positive balancing filter 2-8to 2-9

setting the magnification and calibrating the scanner 2-8

setting the scan parameters 2-8operations tabs (SAM)

backup 3-2, A-2, A-11calibrate/image processing A-6to A-7capture A-8to A-9

mag/focus A-4to A-5miscellaneous A-10

ordering information B-1to B-2accessories B-1supplies B-1

P

parts shipped with Long Roll Accessory D-5phone numbers

service agreement information viii service and support vii

power consumption and thermal load of scanner C-1power switch 1-4, 2-7

powering up the scanner and the host computer 2-7punch readers on the Long Roll Accessory

cleaning D-39

setting height D-14to D-23

R

readers, punch. See punch readers rebooting the scanner A-10regulatory information v

removing the Long Roll Accessory from the scanner D-13replacement procedures 4-4to 4-9

rollers on the Long Roll Accessory, cleaning D-40to D-41

S

SAM. see Service and Assembly Module scan area values

for cut-gate film holders 3-6

for the Long Roll Accessory D-45scan area, setting, in SAM 3-5to 3-6, A-9scan parameters, setting 2-8

scan, checking 3-8scanner attributes A-10scanner specifications C-1

AC voltage and current draw C-1

clearances, for operation and service of scanner C-1dimensions and weight C-1

location C-1

power consumption and thermal load C-1scanning

a single frame 2-13

an image using SAM 3-8, A-9SCSI host adapter 1-5

SCSI interface between host computer and scanner 1-5

I-2

August 2001

Page 114
Image 114
Kodak HR 500 manual Index