Unpacking Instructions for the
KODAK PROFESSIONAL
HR 500 Film Scanner
CAUTION: The HR 500 Film Scanner weighs almost 120 lbs (54,5 kg). Two people are needed to safely lift the scanner from the box.
Be sure the table for the scanner:
•is stable
•can support approximately 120 lbs (54,5 kg)
•is at least 30 in. (76,2 cm) long x 30 in. (76,2 cm) wide
lid
styrofoam
scanner in 
plastic bag
cutouts
styrofoam under scanner
1.Inspect the box to make sure there is no damage. If there is damage, contact the shipping company.
2.Remove the lid from the box.
3.Remove the scanner accessories (such as cables and SCSI board) from the front compartment of the box.
4.Compare the packing list to the actual contents. If there is an item missing:
•In the United States: call Eastman Kodak Company at
•Outside the United States: contact your local Kodak representative.
5.Open the plastic bag that covers the scanner and move the bag so you can reach the cutouts in the styrofoam under the scanner.
CAUTION: Two people are needed to lift the scanner from the box.
6.Use the styrofoam cutouts to reach under the scanner (one person in front; one person in the rear) and lift the scanner out of the box onto the table.
7.Keep the scanner packing material until you are satisfied that the scanner is operating satisfactorily.
front | CAUTION: Make sure the setting on the AC input | |
compartment | ||
module on the back of the scanner is | ||
with | ||
compatible with the power source. | ||
accessories | ||
|
August 2001 | iii |
