Kompernass KH 1099 manual Items supplied, Description, Placement, Before the first use

Items supplied

•Wok with heat insulated handles

•Thermo-plinth with temperature controller

•Glass lid

•Heat-insulated lid handle with mounting materials

•removable drip grill

•2 wooden spatulas, 1 wooden spoon, a pair of chopsticks

•Operating manual

Description

1 Lid handle

2 Glass lid

3Wok

4Heat insulated handles 5 Power cable

6 Heating coil

7 Thermo-plinth

8 Temperature regulator

9 Control lamp

Accessory:

0 Drip grill

q 2 wooden Spatulas w Wooden spoon

eChopsticks

Placement

Place the switched-on Wok exclusively on level, firm and heat-resistant surfaces in a dry environment.

Important!

To avoid the risks of heat damage and fire in the area adjacent to the switched on Wok, always ensure that …

•the switched-on Wok is at all times located at a minimum distance of 50 cm from walls, furniture and other objects.

•no objects are suspended above the switched-on Wok (e.g. lamps).

•there are no easily inflammable objects close to the switched-on Wok (e.g. materials/textiles).

•the power cable 5 and the thermo-plinth 7 are not located close to hot surfaces or open flames.

•the power cable 5 does not, and cannot, make contact with the thermo-sockel 7.

•no moisture and/or fluids can permeate into the thermo-sockel 7.

Non-compliance heightens the risk of fire or of receiving an electrical shock!

Before the first use

Remove all components of the Electrical Wok from the packaging. Remove all remaining protective foils and clean the packaging/dust residues from all components that will come into contact with foodstuffs.

Do not use any abrasive cleaners or scouring pads, these will destroy the non-stick surfaces of the Wok 3 and impair their effectiveness!

Mounting the lid handle

1.Place the lid handle 1 onto the broad insulating wafer so that the rectangular retainer protudes into the lid handle 1.

2.From above, lay the broad insulating wafer with the lid handle 1 on the glass lid 2, so that the holes lie one above the other.

3.Firstly, place the metallic washers over the screws. Then place the rubber washers onto the screws so that the broad sides lie flat against the metallic washers.

4.From below, insert the screws with both washers through the holes and then screw them tight with a cross-head screwdriver.

- 4 -