Settings for recording

Checking the external input

Before you begin, go to “Song settings” (page 7 of this manual) and select an audio track (AT1 for this example).

1Access the Sequencer mode P1 tab 5 page (ATrkRec).

2

3

6 4 1

2Select the Input Select item.

If you are recording from an analog device such as a guitar connected to the ANALOG IN 1 or 2 jack, select Analog.

Input from the ANALOG IN 1 jack will be recorded on audio track 1 or 3. Input from the ANALOG IN 2 jack will be recorded on audio track 2 or 4.

If you are recording from a digital device such as a DAT connected to the S/P DIF connector, select Digital. In this case, make sure that the Global mode P2 System Clock setting is set to S/P DIF. If you are recording from a digital device, proceed to step 6 .

If a digital signal containing a copy inhibit flag is input, the display will indicate Copy Inhibit. The HDR-TRIis able to record a digital signal which contains the SCMS (Serial Copy Management System) flag. However it will be recorded as digital audio data without the SCMS flag.

When digitally recording from copyrighted audio material such as a com- mercial DAT tape, you must be sure to obtain permission. Otherwise, you must use non-copyrighted material. Korg will take no responsibility for the consequences of any copyright violation which you may commit.

Input from the S/P DIF connector will be recorded with the left channel of the source on audio track 1 or 3, and the right channel on audio track 2 or 4.

It is not possible to record a sampler or CD with a sampling frequency other than 48 kHz via the S/P DIF connector. If you wish to record from such a sampler or CD, use the ANALOG 1 or 2 jacks.

8

Page 11
Image 11
Korg HDR-TRI manual Checking the external input