Messages
Messages
When the
Disk not formatted
Meaning: The disk for which Wipe was attempted is not formatted.
Action: Use the Format command of the TRINITY to format the disk.
Error in wiping medium
Meaning: Disk wipe could not be performed.
Action: The disk is damaged. Use a different disk.
Memory full. Audio track can’t play to the end.
Meaning: The master track's memory has been used up, so the audio track can- not be played back to the end.
Action: Increase the available memory of the master track by deleting tempo changes etc. from the master track.
No unused sounds found
Meaning: When you executed the Disk mode command Delete Unused Sound, no unused sounds were found.
Troubleshooting
Problem: An asterisk “ 
” appears to the right of the page menu button (as shown in the graphic at the right), and problems such as a flickering LCD and a drop in volume occur.
If you continue using the unit under these circumstances, functions may stop working properly. Take the following actions immediately.
Cause: The clock is not being detected correctly. The cable connected to the S/P DIF IN connector may not be plugged in, a frequency other than 48 kHz may be transmitting to the S/P DIF IN connector or for a sim- ilarly related reason. Also, if the
Action: First, confirm that the connected cable is working. Then, input the correct clock [48 kHz (± 5 Hz) to both the S/P DIF IN connector and the WORD CLOCK IN connector], and set the Global mode P1 (Glo- bal Setup) parameter System Clock to “Internal.” Before continuing to use the unit, make sure that normal operation has resumed and that the asterisk “ 
” is no longer displayed next to the page menu button. If these steps do not restore normal operation, turn the power off and back on. You must first back up the Sequencer memory since all data will be lost when the power is turned off.
Problem: Sound is distorted.
Cause 1: If the Sequencer mode P1 tab 5 page (Audio Track Rec) settings for Input Level and/or Rec Level are excessively high (and the display indicates Overload and/or Over), the input will be overloaded and distorted sound will be recorded.
56
