Kyocera FS-C5016N manual Changing Serial Interface Parameters, Parallel I/F ? Nibble high

				3.5 Changing the Interface Parameters
7	To change the communication mode, press the ENTER key. A blinking question
	mark (?) appears.
			>Parallel I/F
		? Nibble (high)
8	Press the U or V key to scroll through the following communication modes:
	Nibble (high)
	Auto
	Normal
	High Speed

9

10

When the desired communication mode is displayed, press the ENTER key.

Press the MENU key to exit the menu selection.

3.5.2Changing Serial Interface Parameters

This section applies to the printer having the optional serial interface board kit (IB-11) installed.

Note

You can confirm or change the serial interface parameters including baud rate, data bits, stop bits, parity, and protocol. These parameters must match those of the computer’s serial interface.

1

2

3

4

Press the MENU key.

Press the U or V key repeatedly until Interface > appears.

If the interface is other than serial, press the ENTER key. A blinking question mark (?) appears.

Interface

?Parallel

Press the U or V key repeatedly until Serial appears.

Interface

?Serial

5

6

Press the ENTER key again.

Press the Z key. One of the following serial parameters is indicated (Baud rate for example).

3-35