Kyocera FS-C5016N manual Error Messages, Message Corrective Action

4.3 Error Messages

4.3Error Messages

The following table lists errors and maintenance messages that you can be dealt with by yourself. If Call service appears, turn off the printer, disconnect the power cord, and contact your Kyocera Mita dealer.

Some errors cause the alarm sound to sound. To stop the alarm sound, press the CANCEL key to stop the alarm sound.

Message		Corrective Action
		The paper has run out in the paper source displayed. Supply paper according
Add paper MPTray
		to the paper source displayed (paper cassettes, MP tray, optional paper feed-
		ers, or optional envelope feeder).
		This message is displayed alternately with messages indicating the printer
		status, such as, Ready, Please wait, Processing, Waiting, and
		Form Feed Time Out. If the number of copies to print is 2 or more,
		only the Add paper message is displayed.
		F### represents a controller error (#=0, 1, 2, ...). Call for service. The
Call service
F###:		printer does not operate when this message is displayed.
		#### represents a mechanical error (#=0, 1, 2, ...). Call for service. The
Call service
####:0123456		printer does not operate when this message is displayed. The total number of
		pages printed is also indicated, e.g. 0123456.
		This message means an error in data communications between the printer
Call service
		controller and the operator panel. Call for service.
Person	F0

Cassette # not loaded

The corresponding paper cassette is not installed. Install the cassette. The cassette number can be 1 (topmost) to 4 (bottom).

Check waste toner box

This message warns following two cases. Install the new waste toner box.

•The waste toner box is not installed.

•The waste toner box is almost full.

Clean printer	Please clean the inside of the printer. See Chapter 5 Maintenance, section
	5.3 Cleaning the Printer on page 5-11.
Press GO
	This message will be displayed when replacing the toner container after the
	message Replace toner C, M, Y, K is displayed. After cleaning the
	inside of the printer, press the GO key and the printer will be ready for print-
	ing.
	If Auto Continue is set to On, printing will be automatically resumed after a
	preset period of time. For details on Auto Continue, refer to Chapter 3 Using
	the Operator Panel, section 3.13.8 Auto Continue Setting on page 3-97.

Close duplexer	The rear unit of the optional duplexer is open. Close the duplexer rear unit.
rear unit

Close duplexer top cover

The top cover of the optional duplexer is open. Close the duplexer top cover.

Close paper transfer unit

The paper transfer unit is open. Close the paper transfer unit.

Table 4-3

4-7