Kyocera FS-C5016N manual Using the Operator Panel, section Formatting a Memory Card

4.3 Error Messages

Message Corrective Action

Close left cover

The left cover of the printer is open. Close the left cover.

Close rear cover

The rear cover of the printer is open. Close the printer rear cover.

Close top cover

The top cover of the printer is open. Close the printer top cover.

Duplex disabled	You attempted to print with a paper size and paper type that cannot be used
	for duplex printing. Press the GO key to print onto one-side of the paper
Press GO
	only.
	The face-down tray has become full (approx. 250 pages). You must remove
Face-down tray
	all printed pages from the face-down tray. When the printer detects that the
paper full
	face-down tray is empty again, the printer will continues printing into the
	face-down tray.

File not found Press GO

You have attempted to print a job that is not contained in the specified virtual mailbox, or the specified virtual mailbox is not found.

If Auto Continue is set to On, printing will be automatically resumed after a preset period of time. For details on Auto Continue, refer to Chapter 3 Using the Operator Panel, section 3.13.8 Auto Continue Setting on page 3-97.

Format error	The hard disk installed in the printer is not formatted, and therefore cannot
	be read or written. To format the hard disk, follow the procedure in the
Hard disk
	Installation Guide of the hard disk.
	The memory card inserted in the printer is not formatted, and therefore can-
Format error
	not be read or written. To format a memory card, follow the procedure in
Memory card
	Chapter 3 Using the Operator Panel, section Formatting a Memory Card
	on page 3-63.

Hard disk err ##	A hard disk error has occurred. Look at the error code given in place of ##
Press GO	and refer to Storage Error Codes on page 4-11. To ignore the hard disk error,
	press the GO key.
	This message is displayed when you attempt to use the printer’s operator
I/F occupied
	panel to change the environmental settings on the interface from which data
	are presently being received.

ID error

The user ID entered for a private job, or a stored job is not correct. Check the user ID that you specified on the printer driver.

Insert the same memory card

You have inserted the wrong memory card when the Insert again mes- sage was displayed. Remove the wrong memory card from the printer’s memory card slot and insert the correct memory card. The printer again reads it from the beginning of the data.

Install MK

Replace Maintenance Kit which is displayed on the message display. Replacement of the maintenance kit is necessary at every 200,000 images of printing and requires professional servicing. Contact your Kyocera Mita dealer.

KPDL error ## Press GO

Current print processing cannot continue because of occurrence of KPDL error which is categorized by ##. To print out an error report, display > Print KPDL err(s) from the menu system, and select On. Press the GO key to resume printing. You can abandon printing by the CANCEL key.

If Auto Continue is set to On, printing will be automatically resumed after a preset period of time. For details on Auto Continue, refer to Chapter 3 Using the Operator Panel, section 3.13.8 Auto Continue Setting on page 3-97.

Table 4-3 (Continued)

4-8