Kyocera FS-C5016N manual Resolving IP Address, Off IP Address 000.000.000.000 Subnet Mask Gateway

3.5 Changing the Interface Parameters

3.5.4Resolving IP Address

To connect the printer to the network using TCP/IP protocol, you must set the IP address on the printer. The IP address must be unique to the printer and should be obtained from your network administrator.

1	Activate TCP/IP protocol in the manner described above.
		>TCP/IP	>
		On
2
	Enter the submenu by pressing the Z key. Each time you press the U or V key, the
	selection changes as shown below.
		>>DHCP
		Off
		>>IP Address
		000.000.000.000
		>>Subnet Mask
		000.000.000.000
		>>Gateway
		000.000.000.000
3
	When >>IP Address is displayed, press the ENTER key. A blinking cursor (_)
	appears at the last digit.
		>>IP Address
		000.000.000.000
4
	Press the U or V key to increase or decrease, respectively, the value at the blinking
	cursor. Use the Z and Y keys to move the cursor right and left.

5

6

When the IP address is entered, press the ENTER key.

Press the U or V key to move to Subnet Mask. Perform the same procedure to complete entering the subnet mask address.

7	Then, press the U or V key to move to Gateway. Perform the same procedure to
	complete entering the subnet mask address.
8	Press the MENU key. The display returns to Ready. You can print a network status
	page to confirm that the IP address, subnet mask address, and the gateway address

have been properly set. To print a network status page, see Printing a Network Interface Status Page which follows.

3-39