Lexmark 436 TCP/IP menu, Network/Ports Standard Network Standard Network Setup TCP/IP, IP Address

Understanding printer menus	136
Use	To
Job Timeout	Set the amount of time it takes for a network print job to be canceled.
0, 10–225 seconds	Notes:
	• 90 seconds is the factory default setting.
	• A setting value of 0 disables the timeout.
	• If a value between 1 and 9 is selected, then Invalid appears on the
	display, and the value is not saved.

TCP/IP menu

To access the menu, navigate to either of the following:

•Network/Ports > Standard Network > Standard Network Setup > TCP/IP

•Network/Ports > Network [x] > Network [x] Setup > TCP/IP

Note: This menu is available only in network printers or printers attached to print servers.

Use	To
Set Hostname	Set the current TCP/IP host name.
	Note: This can be changed only from the Embedded Web Server.
IP Address	View or change the current TCP/IP address.
	Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
	settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
	support BOOTP and RARP.
Netmask	View or change the current TCP/IP netmask.
Gateway	View or change the current TCP/IP gateway.
Enable DHCP	Specify the DHCP address and parameter assignment.
On	Note: On is the factory default setting.
Off
Enable RARP	Specify the RARP address assignment setting.
On	Note: Off is the factory default setting.
Off
Enable BOOTP	Specify the BOOTP address assignment setting.
On	Note: On is the factory default setting.
Off
Enable AutoIP	Specify the Zero Configuration Networking setting.
Yes	Note: Yes is the factory default setting.
No
Enable FTP/TFTP	Enable the built-in FTP server, which lets you send files to the printer using File Transfer
Yes	Protocol.
No	Note: Yes is the factory default setting.
Enable HTTP Server	Enable the built-in Web server (Embedded Web Server). When enabled, the printer
Yes	can be monitored and managed remotely using a Web browser.
No	Note: Yes is the factory default setting.