Administrative support
Enabling operator panel menus
1Turn the printer off.
2Press and hold 
and 
while turning the printer on.
3Release the buttons when you see a clock.
CONFIG MENU appears on the first line of the display.
4Press 
until the 
appears next to Panel Menus, and then press 
.
5Press 
until the 
appears next to Enable, and then press 
.
The following messages appear briefly in succession: Submitting selection and Enabling Menus. The operator panel returns to Panel Menus.
6Press 
until the 
appears next to Exit Config Menus., and then press 
.
Activating Menu Changes appears. The menus are enabled, and the printer returns to Ready.
Restoring factory default settings
When you first enter the printer menus from the operator panel, you may notice an asterisk (*) to the left of a value in the menus. This asterisk indicates the factory default setting. These settings are the original printer settings. (Factory defaults may vary for different regions.)
When you select a new setting from the operator panel, Submitting Selection appears. When the Submitting Selection message disappears, an asterisk appears next to the setting to identify it as the current user default setting. These settings are active until new ones are stored or the factory defaults are restored.
To restore the original printer factory default settings:
Warning: All downloaded resources (fonts, macros, and symbol sets) in printer memory (RAM) will be deleted. (Resources residing in flash memory or on the optional hard disk remain unaffected.)
1Make sure the printer is on and Ready appears on the display.
2Press 
on the operator panel.
3Press 
until the 
appears next to Settings, and then press 
.
4Press 
until the 
appears next to Setup Menu, and then press 
.
5Press 
until the 
appears next to Factory Defaults, and then press 
.
6Press 
until the 
appears next to Restore Now, and then press 
.
The message Restoring Factory Defaults appears, followed by the Ready message.
When you select Restore:
•No other button actions are available on the operator panel while Restoring Factory Defaults appears.
•All menu settings return to the factory default values, except:
–The operator panel Display Language setting in the Setup menu.
–All settings in the Parallel menu, Serial menu, Network menu, and USB menu.
Enabling operator panel menus
97
