EZ-Manager Wizard (Cont.)

(Continued from previous page)

When the Pro:Centric configuration is complete, an EZ-Manager Configuration Complete screen (see example on page 20) is displayed, and after 10 seconds, the wizard exits, and the STB turns OFF.

Note: With the EZ-Manager Configuration Complete screen on display, you can also manually turn off or reboot the STB. If desired, select TURN OFF or REBOOT, respectively, and then press OK on the Installer Remote.

USB Configuration

The STB Manager / USB Download Menu provides options that enable you to download individual configuration or software files to the STB, or you can use the Ez Download utility available from the menu to select and download multiple configuration or software files at one time.

Each of the STB Manager / USB Download Menu functions requires that you have the appropriate file(s) loaded on a USB memory device. If you wish to perform a software update from the STB Manager / USB Download Menu, the software update file(s) must be stored in a folder named “LG_DTV” in the root directory of the USB memory device. TLX files should simply be stored in the root directory of the USB device.

The procedure below assumes the desired file(s) is/are already loaded onto the USB device. For further information on STB Manager / USB Download Menu functions and file requirements, and/ or for information on creating TLX files, refer to the appropriate section(s) in this document.

Before You Begin

•If you intend to use the Zoning feature(s) on this STB, make sure to assign the appropriate TV Zone # and/or Wi-Fi Zone # in the EZ-Manager’s Zones, Label, and Room Number screen

BEFORE continuing with USB Configuration. See “STB Configuration Options” on page 17 for further information.

•Ensure the USB device to be used has been formatted with FAT format.

•Refer to “Ez Download Utility” on pages 25 to 28 for further information on the Ez Download utility.

•Refer to “Custom Master STB Setup” on pages 39 to 41 for information on creating a TLX file for cloning purposes, and/or refer to “Creating an FTG Configuration File” on pages 48 to 49 for information on creating a FTG Configuration (.tlx) file for FTG Mode configuration.

•See Reference section, “Updating STB Software using a USB Memory Device,” for further information on software updates.

USB Configuration via EZ-Manager Wizard

With either the STB Configuration Options or the Zones, Label, and Room Number screen on display, proceed as follows to configure the STB/display using the USB memory device.

1.Insert the USB memory device that contains the appropriate file(s) into either of the STB’s USB ports.

(Continued on next page)

206-4272

23