Custom Master STB Setup (Cont.)

Custom Master STB Setup Procedure

1.Turn ON the STB/display panel.

The next step depends on whether the EZ-Manager Wizard appears on the screen when you turn ON the STB/display:

•If the wizard is displayed, the STB is in the required factory default state. Exit the wizard, and then continue with step 2.

•If the wizard is not displayed, restore the STB to a factory default condition before continuing with this procedure. See Reference section, “Restoring Factory Defaults on the STB(s),” as necessary, for further information.

2.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master STB. Refer to pages 29 to 38 for detailed information on all Installer Menu items.

a) Use the Installer Remote to access the PTC Installer Menu (see “Accessing the Installer Menu” on page 29 for further information).

b) Set Installer Menu item 003 BAND/AFC, as appropriate.

•

Broadcast: Set to 0.

•

HRC: Set to 2.

•

CATV: Set to 1 (default).

•

IRC: Set to 3.

c)Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, set the panel display type (if applicable), enable/disable Aux inputs, set a Start Channel, etc.

d)After you have adjusted all Installer Menu item settings as required, and if you do not need to configure any IP Environment settings (see note below), press OK once on the Installer Remote to save your changes; then, press OK again to exit the menu.

Note: If you intend to configure settings in the IP Environment Menu, which is accessible from the Installer Menu, you can proceed directly to step 3. All Installer Menu settings will be saved automatically when you access the IP Environment Menu.

3.Configure IP Environment settings.

Note: You cannot return directly to the Installer Menu from the IP Environment Menu; thus, you may wish to set all Installer Menu items as needed before you access the IP Environment Menu. Otherwise, you will need to reaccess the Installer Menu to set additional items.

Navigate to Installer Menu item 119 DATA CHANNEL, and press

2-5-3+ MENU to launch the IP Environment Menu. Then, complete network configuration as required. In particular, if you intend to use the Wi-Fi Zoning feature, you must configure the wireless network connection as part of the Master STB Setup. See “IP Environment Setup” on pages 54 to 61 for further information.

STB_3000 PTC INSTALLER MENU

CPU-CTV

 

000

INSTALLER SEQ 000

 

 

 

 

 

 

 

UPN

000-000-000-000

ASIC D279

 

 

PTC

V1.00.008

CPU V3.00.34.01

 

 

 

Typical Installer Menu

 

 

 

 

003 BAND/AFC

001

 

 

 

Adjust the value for this

Installer Menu item, as required.

(Continued on next page)

40

206-4272