LG Electronics STB-3000 STB-3000Cabling Connections (Cont.)

STB-3000 Cabling Connections (Cont.)

(Continued from previous page)

While the STB is turning ON and sending the turn ON command to the display, the STB LED blinks at a constant rate. Once both the STB and the display panel are ON, the STB LED remains lit but blinks off twice in rapid succession every five seconds. The first image you should see on the display panel is a prompt to select the screen resolution (see “Setting the Video Output Resolution” on page 14).

4.Select the video output resolution (i.e, the STB’s video output format), and complete the appropriate Commercial Mode setup procedures, as described in this document.

Note: It is recommended that you complete STB-3000 Commercial Mode setup procedures before you make external equipment connections to the STB-3000.

STB-3000 Cabling Diagram

See also step 2 of procedure above.

STB-3000 Front Panel

DISPLAY	MPI
CONTROL 2	(ARC)IN 1	IN 2	USB IN 2
			USB IN 2

USB IN 1

a)Connect DISPLAY CONTROL 2 to LG Hospitality

display panel MPI port or to commercial non-LG TV MTI (DATA) port. *

a) Connect DISPLAY

CONTROL 1 to LG Public

Display or Commercial Monitor

display panel RS-232 port. *

b) Connect HDMI OUT on STB to HDMI IN on display panel. **

STB-3000 Rear Panel

POWER	OUT	LAN	DIGITAL	AUDIO			DISPLAY			ANTENNA/
			AUDIO		AV IN	IR IN		1	SERVICE	CABLE IN
				LINE OUT			CONTROL

c) & d) Complete STB Power and Antenna/Cable connections.

* Only one DISPLAY CONTROL connection should be used. The proper connection depends on the type of display panel to be controlled.

** The STB default configuration automatically sends Display Control commands to switch the connected display panel to its HDMI1 input.

206-4272