Cloning Procedures (Cont.)
(Continued from previous page)
9.When you are ready to initiate the Teaching process, select UPDATE on the screen and then press OK on the Installer Remote.
TEACH TO STB (TLX)STB MANAGER
BACKCANCEL
Select USB Memory Device | ˇ | Channel Tuning / Channel Banner Display |
USB Device 1: Device Name | |
Logical
Select the file to download, and then select UPDATE below. | Physical |
|
STB-3000-UA00001.TLX | |
UPDATE
Teaching status will be shown in a pop-up progress banner at the bottom of the Teach To STB (TLX) screen. This process may take a few minutes. Do NOT remove the USB device until Teaching is complete. When the Teaching process is complete, an “Updating completed” message is briefly displayed, and the STB Manager / USB Download Menu is exited (see also note below).
Note: If you updated the STB configuration with a TLX file that included a change to Installer Menu item 105 VID OUT FORMAT, once Teaching is completed, a Changing Screen Resolution banner will be displayed, and the STB will reboot within a few seconds to change the resolution per your selection. The new screen resolution will also require user confirmation after reboot. See item 105 description on page 37 for further information.
10.Remove the USB memory device from the Target STB, and verify that the appropriate configuration is now resident on the Target STB.
Note: If the Target STB was previously in Pass-through Mode, and the TLX file used for Teaching contained an FTG Channel Map, the Target STB CPU is now in FTG Mode. After the Teaching process (and, if applicable, an STB reboot/confirmation of new screen resolution) is complete, the STB tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is specified, the STB will tune to that channel, though, in the case of FTG Mode configuration, a channel banner will only be displayed if the Start Channel is included in the FTG Channel Map (depending on your selection in step 8, the channel banner will display either the Start Channel’s logical channel number or physical RF channel number). Otherwise, the STB will either return to the last channel tuned (STB in Pass-through Mode) or tune to the first channel in the FTG Channel Map (STB in FTG Mode). If the latter, remember that the channels in the FTG Channel Map are always arranged in logical order, regardless of your selection in step 8.