Cloning Procedures (Cont.)
(Continued from previous page)
•If the TLX file contains an FTG Channel Map that was Learned from an STB, the physical RF channels in the FTG Channel Map have been assigned logical channel numbers (see “Learning
Configuration from a Master STB” above). When you Teach the FTG Channel Map to the Target
STB(s), you will have the option to select either logical or physical channel tuning. Even if you select physical channel tuning, the (list of) physical RF channels in the FTG Channel Map will remain in logical order.
•If the TLX file contains an FTG Channel Map that was created in the FTG File Manager, each logical channel number in the FTG Channel Map has been assigned a physical RF channel, an IP channel, or an Aux input (the latter designated by
Note: When you Teach the FTG Channel Map to the Target STB(s), depending on the types of channels included in the FTG Channel Map, you may have the option to select either logical or physical channel tuning. If you select physical channel tuning, the physical RF channels and Aux inputs in the FTG Channel Map will remain in logical order.
•If the TLX file was created in the FTG File Manager, it may contain multiple zoned FTG Installer Menu profiles for different STB/TV models. Make sure it includes the appropriate Installer Menu profile(s) for the Target STB(s) before Teaching.
Caution: Do not unplug the STB power cord or remove the USB memory device while Teaching, as doing so may cause the STB to malfunction or harm the USB device, respectively.
Teach Configuration to Target STB
1.Turn ON the Target STB/display panel.
2.The next step depends on whether the
•If the wizard is displayed, you can complete the Teaching process via the wizard, as indicated above (see “Before You Begin”). However, to continue with this procedure and access the “Teach to STB (TLX)” option from the STB menus, exit the
•If the wizard is not displayed, go directly to step 3.
3.If applicable (see also “Before You Begin” above), make sure to assign the appropriate Zone designation(s) in the Target STB at this time.
Note: In order for the proper
4.Insert the USB memory device with the TLX file into either of the USB ports on the Target STB.
5.Press MENU on the Installer Remote to display the STB setup menus (STB is in
(Continued on next page)
45 |