IP Environment Setup

The IP Environment Menu enables you to set up the network features of the STB. If you intend to create a Master STB Setup for cloning purposes (see Master STB Setup procedure on pages 39 to 41), all IP Environment settings, with the exception of Wired Network Connection settings, the STB name (editable in the Media Share Menu), and Soft AP settings, may be cloned.

Note: With the exception of Network Setting configuration, the IP Environment settings are editable (with the Installer Remote) only if the STB is in Pass-through Mode and read-only when the STB is not in Pass-through Mode.

Accessing the IP Environment Menu

Note: When you enter the IP Environment Menu, the Installer Menu is exited (all current settings are saved automatically upon exit). If you are also in the process of updating Installer Menu items, you may wish to set all items as needed before you access the IP Environment Menu. Otherwise, after exiting the IP Environment Menu, you will need to reaccess the Installer Menu to set additional items.

1.Use the Installer Remote to access the Installer Menu (see “Accessing the Installer Menu” on page 29 for further information).

2.Navigate to Installer Menu item 119 DATA CHANNEL, and press 2-5-3+ MENU to launch the IP Environment Menu.

Use the Up/Down arrow keys on the Installer Remote to select the desired menu option and then press OK. Refer to the following sections for information on each of the IP Environment setup options.

When you have completed your IP Environment configuration as required, press EXIT or on the Installer Remote to exit the IP Environment Menu.

Pro:Centric Setup

Pro:Centric options enable you to configure the STB with the appropriate settings to connect to the Pro:Centric server. Use the Up/ Down arrow keys on the Installer Remote to navigate between fields.

1.With the IP Environment Menu on display, use the arrow keys on the Installer Remote to select the Pro:Centric menu option. Then, press OK.

2.Refer to the appropriate subsection(s) below to configure the

STB’s Pro:Centric settings to match those of the Pro:Centric server.

While the Pro:Centric application (Mode) itself is an additional feature, the appropriate Pro:Centric server configuration must be completed to enable E-Z Installation (configuration and software/ firmware) data downloads and, if configured, the Pro:Centric application download.

Note: By default, the Pro:Centric Menu initially shows RF configuration fields. When you select “IP” as the Media Type, the Data Channel field is replaced with IP Address and Port Number fields.

Pro:Centric PRO:CENTRIC

 

Network

 

 

 

Mode ^

 

 

Configuration Only

 

Pre-loaded App

Media Type ^

 

RF

 

 

 

 

Data Channel

AUTO

 

Update Event

OFF

(Continued on next page)

54

206-4272