Cloning Procedures (Cont.)

(Continued from previous page)

Learning status will be shown in a pop-up progress banner at the bottom of the Learn From STB (TLX) screen. This process may take a few minutes. Do NOT remove the USB device until Learning is complete. When the Learning process is complete, a “Saving completed” message is displayed.

9.Press OK to return to the Learn From STB (TLX) screen. To return to the STB Manager / USB

Download Menu, press on the Installer Remote or select BACK from the Learn From STB (TLX) screen. To return to program viewing, select CANCEL.

10.Remove the USB memory device from the Master STB.

Note: If the Master STB has a channel lineup, during Learning, logical channel numbers are automatically assigned in ascending order, starting with 0 (zero), to the physical RF channels of the STB channel lineup to create an FTG Channel Map. See also note below.

Note: If the newly Learned TLX file is to be used for FTG Mode via CPU configuration (i.e., it contains an FTG Channel Map), it is highly recommended that you open the file in the FTG File Manager—BEFORE transferring (Teaching) the file to any Target STBs—to verify FTG Channel Map and FTG Installer Menu settings and enable decryption by marking Pro:Idiom encrypted channels. This will also enable you to confirm channels and add channel attributes, labels, etc.

Teaching Configuration to a Target STB

This section describes how to transfer (Teach) a TLX file from a USB memory device to an STB using the STB Manager / USB Download Menu “Teach To STB (TLX)” option. The TLX file may be created either from a Master STB Setup that was saved (Learned) from a Master STB or in the FTG File Manager.

Before You Begin

•Ensure the USB device has been formatted with FAT format.

•If the EZ-Manager Wizard appears on the screen when you turn ON the Target STB/display panel, you can use the wizard’s “USB Configuration” option to access the STB Manager / USB Download Menu and complete the Teaching process (see “STB Configuration Options” and/or “USB Configuration” on pages 17 and 23, respectively, as necessary).

•You may also use the Ez Download utility to complete the Teaching process. See “Ez Download Utility” on pages 25 to 28 for further information.

•If the Target STB is currently in Pass-through Mode and you intend to use the STB’s Zoning feature(s)—i.e., the TLX file you are Teaching contains an FTG Channel Map and/or FTG profile(s) with TV Zone and/or Wi-Fi Zone assignments—make sure to assign the appropriate TV Zone # and/or Wi-Fi Zone # in the STB when directed to do so in the procedure below. See Reference section, “Using the STB’s Zoning Features,” for further information.

•If you would like the Target STB(s) to remain in Pass-through Mode after Teaching, ensure the TLX file does not contain an FTG Channel Map; otherwise, Teaching will result in the Target STB(s) being configured for FTG Mode.

(Continued on next page)

44

206-4272