5. Programming keypad
5.3Moving to other groups
There are 4 different parameter groups in
Drive group | Function |
| group 1 |
| Function |
| group 2 |
I/O group
Drive group | Basic parameters necessary for the inverter to run. Parameters such as Target |
| frequency, Accel/Decel time are settable. |
|
|
Function group 1 | Basic function parameters to adjust output frequency and voltage. |
|
|
Function group 2 | Advanced function parameters to set parameters for such as PID Operation |
| and second motor operation. |
|
|
I/O (Input/Output) | Parameters necessary to make up a sequence using |
group | input/output terminal. |
|
|
Moving to other parameter groups is only available in the first code of each group as the figure shown below.
Moving to other groups using the Right (X) key | Moving to other groups using the Left (W) key | |||
| * |
| * | |
| Drive group |
| Drive group | |
I/O group | Function | I/O group | Function | |
group 1 | group 1 | |||
|
| |||
| Function |
| Function | |
| group 2 |
| group 2 |
*Target frequency can be set at 0.0 (the 1st code of drive group). Even though the preset value is 0.0, it is