Lincoln Electric SVM132-A Connections to Wire Feeder, Locking, Screw, Control, Cable, Extension

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

Return to Master TOC

A-16		INSTALLATION		A-16
	FIGURE A.12 – INPUT CONTROL CABLE AND ELECTRODE CABLE EXTENSIONS
	WIRE￿
	DRIVE￿		POLARIZED￿	CONTROL￿
	UNIT
		CONTROL￿	PLUGS
				CABLE

CABLE￿

EXTENSION

					ELECTRODE￿
	ELECTRODE￿				CABLE
	EXTENSION￿	BRASS￿		WIRE￿
	CABLE		HAND￿	REEL￿
		BLOCK	CRANK	BASE
2. The standard cable setup consists of an electrode
cable and a control cable with a polarized plug on			FIGURE A.13 – CABLE EXTENSION
the wire feeder end. Position the control cable			CONNECTIONS TO WIRE FEEDER
with the polarized plug at the wire reel base. Refer
to Figure A.12.

3. Connect the electrode cable to the brass block on the hand crank assembly using the screw provided.

4.	Position the 22-1/2 or 45 ft (6.9 or 13.7 m) control		LOCKING￿
	cable extension so the polarized connector with
			SCREW
	the threads on its O.D. is at the wire reel base.
5.	Connect the polarized connectors of the control		CONTROL￿
	cable together.		CABLE￿
6.	Place both the control and electrode cables under		EXTENSION
	the clamp on the wire reel base and tighten the
	screws.
7.	Insert the connector on the electrode cable
	extension into the brass block of the hand crank	REAR￿
	assembly and tighten with a 3/16 in. Allen wrench.
		BRASS￿
8.	At the wire feeder, connect the polarized plug of	BLOCK
		ELECTRODE￿	INGOING￿
	the control cable extension into the mating
	receptacle on the back of the wire feeder. Refer to	CABLE￿	GUIDE￿
	Figure A.13.	EXTENSION￿	TUBE
		CONNECTOR

LN-8