Lincoln Electric SVM132-A K163 Undercarriage Requires K303, K377, or K378, K178 Mounting Platform

C-3 ACCESSORIES C-3

Return to Master TOC

TOC

K163 UNDERCARRIAGE (REQUIRES K303, K377, OR K378)

The undercarriage includes casters, wheels, a handle, and related hardware. Casters are mounted at the front and wheels are mounted at the rear of the plat- form. The handle is bolted to the front of the platform so the wire feeder can be tilted back and wheeled like a two-wheel truck. Installation sheet M13424 is provid- ed with the undercarriage.

K178 MOUNTING PLATFORM

This is a turntable type platform for mounting the LN-8 to the top of Idealarc power sources. Bolt the platform to the lift bail per the instructions supplied with the platform.

K58 MAGNETIC SEPARATOR

Useful with any submerged arc equipment. The unit removes foreign magnetic particles from reused sub- merged arc welding flux. Operating instructions are included with the kit.

K119 GRAVITY FEED FLUX CONE

The flux cone is manual feed attachment for the K112 and K113 sub-arc guns that is used instead of the continuous feed flux system. The flux cone attaches to the gun using the screws provided. The cone also includes a new clamp to be used to hold the trigger pod to the gun. Use it in place of the clamp shipped with the gun.

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Section TOC

Return to Master

Return to Master TOC

Return to Master TOC

K261 METER KIT

All LN-8 wire feed units with code no. 7580 to 7925 come equipped with a factory calibrated Speedmeter Trimmer PC board and meter kit receptacle prepared to accept the optional K261 speed-ammeter voltmeter (analog) kit. LN-8 wire feed units no. 7926 and above come with the speedmeter trimmers incorporated into the Control PC board.

K202 BURNBACK KIT

This kit is useful to help prevent the electrode from sticking in the crater at the end of the weld in two types of welding applications:

1.Welding with small diameter wire [0.035 thru 1/16 in. (0.9 thru 1.6 mm)] at fast wire feed speed when there is a tendency to overrun the wire.

2.When the semiautomatic gun is mounted in a fix- ture or on the K62 Squirtmobile in such a manner that it cannot be lifted from the work at the end of the weld.

The kit delays the dropout of the contactor allowing the electrode to burnback from the crater at the end of the weld. The delay time is adjustable for optimum burnback for different sizes, processes, and proce- dures. Installation instructions are shipped with the kit.

K310 FLUX SCREEN

The unit was designed to fit the top of either the stan- dard fill funnel or the K58 magnetic separator. The unit has a steel screen with 0.065 to 0.075 in. open- ings and an air vibrator attached to the frame. The vibrator can be used with air line pressures ranging from 20 through 100 psi.

For ease of handling, the user should connect the incoming air line to the 1/8 in. pipe elbow with the aid of a quick disconnect type air coupling.

It is very important that reclaimed flux to be used in the continuous flux feeding system be passed through the K310 screen or its equivalent.

K320 FLUX TANK

The flux tank is available to permit the LN-8 to be used for submerged arc welding. Installation instruc- tions are shipped with the kit.

K161 MECHANIZED TRAVEL

POWER PACK

The power pack supplies the power needed by the K110 hand travel unit or the K62 Squirtmobile when used with the K114 sub-arc welding gun. Complete installation instructions are shipped with the kit.

LN-8