Lincoln Electric SVM132-A Welding Guns Welding GUN Accessories, Constant Current Conversion Parts

TOC

TOC

C-5	ACCESSORIES	C-5
WELDING GUNS	WELDING GUN ACCESSORIES

Return to Section

Return to Section TOC

Return to Master

Return to Master TOC

INNERSHIELD GUNS

The K126 gun and cable assembly is recommended for most Innershield electrodes at up to 350 amps.

The K115 gun and cable assembly is recommended for up to 450 amps.

The K116 gun and cable assembly is recommended for up to 600 amps.

NOTE: LinconditionerTM guns are recommended for locations where smoke accumulation is a problem and conventional exhaust systems are ineffective. The available smoke removal type Innershield guns and vacuum units can be used in these locations. Instructions are shipped with the equipment.

SUBMERGED ARC GUNS

The K112 gun and cable assembly is recommended for welding up to 500 amps.

K70 FILLET GUIDE

The fillet guide is designed to help guide the K114 sub-arc gun so the operator can make more uniform horizontal fillet welds with less effort. It consists of a vertical plate roller guide and rear wheel assembly. Once the roller guide and rear wheel are adjusted, the weld is easily made by gently pushing the gun into the fillet. The operator does not have to constantly control the drag of the flux cone against the vertical plate or carefully watch the angle of the gun.

K110 HAND TRAVEL UNIT

The mechanized travel unit can be attached to the K114 sub-arc gun and is used to obtain controlled travel speeds ranging from 7 to 60 inches. Since the hand travel unit derives its control power from a mag- amp source, a K161 power pack is required for this mode of operation.

TOC

TOC

The K113 gun and cable is recommended for use up to 600 amps.

The K114 gun and cable assembly is a 600 amp gun that includes a flux valve and receptacle for the K110 or K62.

K62 SQUIRTMOBILE

The Squirtmobile is a self-propelled trackless carriage that carries the K114 sub-arc gun on long welds for automatic welder economy without high fixture costs. To use the LN-8S or LN-8SE with the Squirtmobile, install the K161 mechanized travel power pack.

Return to Section

Return to Section TOC

Return to Master

Return to Master TOC

GMAW GUNS

An expanding line of Magnum GMA gun and cable assemblies are available to allow welding with solid and cored electrodes using the GMAW process. See the appropriate Magnum literature for descriptions of the 100-500 ampere air cooled gun and cables that are available. Gun cable lengths range from 10 to 25 ft. (3.0 to 7.5 m) and feed electrode sizes 0.023 to 3/32 in. (0.6 to 2.4 mm).

NOTE: Magnum GMA welding guns require a K466-1 connector for use with an LN-8 wire feeder.

CONSTANT CURRENT

CONVERSION PARTS

To convert the LN-8N or LN-8NE for welding with a constant current power source, purchase a variable voltage PC board L5039, and constant current dial plate (M12230 for LN-8N and LN-8S models, M13148 for LN-8F models above code 7580).

LN-8