Lucent Technologies 9077 04S, 9077 16S, 9076 Change executables for all dev1 cards Load profile

Configuring the SP Switch Router Adapter

Step 3. Change profile settings

Change executables for all dev1 cards - Load profile

Global values for executable binaries are set at the Load profile in the hw-tablefield. These only change when you want to execute new run-time code in all SP Switch Router Adapter cards.

Here is the path, default settings are shown:

super> read load LOAD read

super> list

hippi = {"" N/A on 0 1 <{1 /usr/libexec/portcards/xlxload.run N/A}+ rmb = { /usr/libexec/portcards/rm.run N/A off 0 1 < > }

hssi = {/usr/libexec/portcards/hssi_rx.run /usr/libexec/portcards+ dev1 = {/usr/libexec/portcards/dev1_rx.run /usr/libexec/portcards+ atm-oc3-v2 = {/usr/libexec/portcards/atmq_rx.run /usr/libexec/por+ fddi-v2 = {/usr/libexec/portcards/fddiq-0.run /usr/libexec/portca+ atm-oc12-v1 = { /usr/libexec/portcards/atm-12.run N/A off 0 1 < >+ ethernet-v1 = {/usr/libexec/portcards/ether_rx.run /usr/libexec/p+ sonet-v1 = {/usr/libexec/portcards/sonet_rx.run /usr/libexec/port+ atm-oc12-v2 = {/usr/libexec/portcards/atm-12v2.run N/A off 0 1 < +

Look at the SP Switch Router Adapter card settings:

super> list dev1 type = dev1 rx-config = 0

rx-path = /usr/libexec/portcards/dev1_rx.run tx-config = 0

tx-path = /usr/libexec/portcards/dev1_tx.run enable-boot-seq = off

mode = 0 iterations = 1 boot-seq-table = < >

To execute different run-time code on the receive side of the SP Switch Router Adapter card,

replace /usr/libexec/portcards/dev1_rx.run with the path to the new code:

super> set rx-path = /usr/libexec/portcards/newdev1_rx.run super> write

LOAD written

SP Switch Router Adapter Guide - 1.4 Update 2 2-27