Introduction to the SP Switch Router Adapter card

Inserting a media card into the SP Switch Router

ESD requirements

!

Caution: Media cards are hot swappable and can be installed when the SP Switch Router is

 

running. However, media cards are highly susceptible to damage from electrostatic discharge.

 

 

You must wear a grounded, conductive wrist strap any time you handle a media card. Make

 

sure the metallic elements in the band directly touch your exposed skin.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SP Switch Router - 4 card

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SP Switch Router - 16 card

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Wrist strap grounding sites

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Card insertion procedure

1When you are properly grounded, remove the media card from its anti-static container.

2Hold the media card with the network ports facing you.

4-card router

Turn the card horizontal, the top of the media card should be on the left, the bottom of the card should be on the right. As you start, make sure you visually identify the left and right guide pair for this particular slot.

Keeping the media card horizontally level, insert the card fully into the slot, you will feel the card joining with the 100-pin connector on the backplane.

16-card router

Hold the card vertically. As you start, make sure you visually identify the top and bottom guide pair for this particular slot. Have one hand under the card, lightly supporting its weight. Rest just the edge of the bottom corner of the card in the bottom guide. Then, bring the top edge of the card into the top guide. This will help you keep the card level as you slide it in.

Keeping the media card vertically upright, insert the card fully into the slot. You will feel the card joining with the 100-pin connector on the backplane.

3When fully inserted, the card’s face plate should be flush against the chassis back panel.

Note: Do not force the card into the slot. Doing so can damage the card or slot connector.

4Tighten the screws at each end of the face plate.

1-8

SP Switch Router Adapter Guide - 1.4 Update 2

Page 24
Image 24
Lucent Technologies 9077 16S, 9077 04S, 9076 manual ESD requirements, Card insertion procedure